HALL RESEARCH, End Points
HALL RESEARCH, End Points
lmparam g STATE
lmparam g CH_SELECT
astparam g hr_devname
astparam s hr_devname %v;astparam save;
lmparam g MY_IP
lmparam g MY_MAC
lmparam g ETH_LINK_STATE
cec_send %v
lmparam g NO_CEC
lmparam g A_ANALOG_OUT_VOL
lmparam g S0_BAUDRATE
astparam s s0_baudrate %v;astparam save;reboot;
astparam g ir_guest_on
astparam s ir_guest_on y;astparam save;reboot;
astparam save;
reboot
exit
e e_reconnect::%v;astparam save;
echo auto > /sys/devices/platform/1500_i2s/io_select;lmparam s A_IO_SELECT auto;astparam s a_io_select auto;echo %v > /sys/devices/platform/1500_i2s/analog_out_vol;lmparam s A_ANALOG_OUT_VOL %v;astparam s a_analog_out_vol %v;astparam save;
The Hall Research VERSA-4K sender is an AV-over-IP encoder that extends 4K HDMI video, USB 2.0, keyboard and mouse, IR, RS-232 and analog audio across a standard gigabit Ethernet network. It accepts up to 4K at 30Hz 4:4:4 with HDCP 2.2 and 1.4, carries an HDMI loop output for a local display, and is PoE powered.
Resolution: Up to 3840x2160 at 30Hz 4:4:4, HDCP 2.2 and 1.4
Type: ASPEED AV-over-IP endpoint, multicast group routing
Inputs: 1x HDMI input with loop output, USB, RS-232, IR, analog audio
Mounting: Surface or rack with the optional shelf
First Use: Put the device on the same subnet as the controller and connect to TCP port 9999. The device answers with a greeting line and a '> ' prompt; consume both before sending a command. The greeting carries the API version, for example 'VERSA-4K Telnet Server V1.2' - read it to learn which command set this firmware supports, because later firmware adds commands that V1.2 rejects as Invalid Command!. There is no authentication. The device takes a DHCP address by default and at most four clients may connect at once.
Video Optimization: Enable jumbo frames at 8000 on the device and on every switch port in the path; SET MTU requires a reboot. The sender accepts up to 4K at 30Hz 4:4:4 on its HDMI input.
CEC: Not available on API V1.2. Later firmware adds a CEC send command; read the greeting to determine whether it is present.
Switch: A sender publishes on its multicast group. Use GET CHANNEL to read the number it is publishing on, then set a receiver to the same number. Changing a sender's group with SET CHANNEL moves every receiver currently watching it.
Tech Support Phone: +1 (408) 962-0515
Power Cycle: Remove PoE or the local power supply for ten seconds, or send RESTART DEVICE over the telnet API. The session drops and the device restarts.
Factory Reset: Send FACTORY RESET over the telnet API, or use the front-panel reset. This clears the device name, group and network settings.
Confirm each command on your device before you rely on it. Provided as is, with no warranty. To correct something or ask for it to come down, write to info@ctrlbot.io. Licensed CC BY 4.0: credit CTRLbot and link back when you share it. Product page. Manufacturer site.