MATROX, End Points
MATROX, End Points
POST /device/settings/streams/video/%o|{"enable":true,"sdpUrl":"%n"}
POST /device/settings/streams/audio/%o|{"enable":true,"sdpUrl":"%n"}
POST /device/settings/streams/video/%o|{"enable":false}
POST /device/settings/streams/audio/%o|{"enable":false}
GET /device/settings/streams/video/%o
GET /device/settings/streams/audio/%o
POST /device/settings/streams/master|{"enable":true}
POST /device/settings/streams/master|{"enable":false}
POST /audio/configuration|{"leftVolume":%v,"rightVolume":%v,"muteEnabled":false}
GET /audio/configuration
POST /serial/sendString|{"string":"%v"}
POST /device/settings/video/passthrough|{"enablePassthrough":true}
POST /device/settings/video/passthrough|{"enablePassthrough":false}
GET /device/settings/video/passthrough
GET /device/caps
GET /device/information
GET /device/status
GET /api/version
POST /audio/configuration|{"leftVolume":%v,"rightVolume":%v,"muteEnabled":true}
POST /audio/configuration|{"leftVolume":%v,"rightVolume":%v,"muteEnabled":false}
The Matrox ConvertIP Series converts HDMI to and from IPMX and SMPTE ST 2110, with a single unit able to run as a transmitter or a receiver. It adds NMOS discovery and routing, PTP timing, HDCP, EDID management and an RS-232 gateway for controlling an attached device over the network.
Resolution: Up to 3840x2160 at 60Hz
Type: IPMX / ST 2110 AV-over-IP converter, transmitter or receiver
Inputs: 1x HDMI in and 1x HDMI out; 3.5mm analog audio; RS-232; dual 1GbE
Mounting: Standalone or rack-mountable
First Use: Put the device on the same subnet as the controller and sign in through the web interface to set the admin password. The driver signs in on connection and uses the returned bearer token for every later request. Read GET /device/caps to learn whether the unit is running as a transmitter or a receiver before routing.
CEC: Not supported. Use SERIAL SEND to control an attached display over RS-232.
Switch: A receiver subscribes by being pointed at a sender's SDP URL. Send ROUTE VIDEO with %o set to the local stream index and %n set to the sender's SDP URL, then send ROUTE AUDIO the same way so audio follows video. Point them at different senders for audio breakaway.
Tech Support Phone: 1-800-361-4903
Tech Support Email: video@matrox.com
Power Cycle: Disconnect power, wait ten seconds, reconnect.
Factory Reset: Refer to the ConvertIP user guide.
Confirm each command on your device before you rely on it. Provided as is, with no warranty. To correct something or ask for it to come down, write to info@ctrlbot.io. Licensed CC BY 4.0: credit CTRLbot and link back when you share it. Product page. Manufacturer site.